1. Home
  2. Cisco
  3. Cisco CCNP
  4. 300-710 Exam Info

Cisco 300-710 Exam Questions - Navigate Your Path to Success

The Cisco Securing Networks with Cisco Firepower (300-710) exam is a good choice for IT Security Consultant Network administrators Security Administrators System Engineer and if the candidate manages to pass Cisco Securing Networks with Cisco Firepower exam, he/she will earn Cisco CCNP, Cisco CCNP Security Certifications. Below are some essential facts for Cisco 300-710 exam candidates:

  • In actual Cisco Securing Networks with Cisco Firepower (300-710) exam, a candidate can expect 65 Questions and the officially allowed time is expected to be around 90 Minutes.
  • TrendyCerts offers 325 Questions that are based on actual Cisco 300-710 syllabus.
  • Our Cisco 300-710 Exam Practice Questions were last updated on: Feb 28, 2025

Sample Questions for Cisco 300-710 Exam Preparation

Question 1

Refer to the exhibit.

300-710 Exam Question 1 Exhibit 1

A Cisco Secure Firewall Threat Defense (FTD) device is deployed in inline mode with an inline set. The network engineer wants router R2 to remove the directly connected route M 68.1.0/24 from its routing table when the cable between routed R1 and the Secure FTD device Is disconnected. Which action must the engineer take?

1

Correct : A

To ensure that router R2 removes the directly connected route for 192.168.1.0/24 from its routing table when the cable between router R1 and the Secure FTD device is disconnected, the network engineer must implement the 'Propagate Link State' option on the Secure FTD device. This option allows the FTD to propagate the link state changes to adjacent devices, ensuring that the disconnection is recognized and the routing table is updated accordingly.

Steps:

Access the FTD device configuration via FMC.

Navigate to the interface settings for the relevant interfaces.

Enable the 'Propagate Link State' option for the interfaces connected to R1 and R2.

Deploy the changes to the FTD device.

This configuration ensures that the link state changes are communicated to router R2, prompting it to remove the disconnected route from its routing table.


Options Selected by Other Users:
Question 2

Which component is needed to perform rapid threat containment with Cisco FMC?

Correct : A

To perform rapid threat containment with Cisco FMC, the necessary component is Cisco Identity Services Engine (ISE). ISE integrates with FMC to provide dynamic network access control and enforcement, allowing for quick isolation of compromised endpoints based on security events detected by FMC.

Steps:

Integrate FMC with ISE by configuring the necessary settings in both platforms.

Define security policies in FMC that trigger rapid threat containment actions via ISE.

When a threat is detected, FMC can instruct ISE to isolate the affected endpoint, limiting its access to the network.

This integration enables automated and efficient threat containment, reducing the response time and mitigating the impact of security incidents.


Options Selected by Other Users:
Cisco 300-710