Cisco 500-220 Exam Questions - Navigate Your Path to Success

The Cisco Engineering Cisco Meraki Solutions (500-220) exam is a good choice for Network administrators Network engineers Network Managers System Engineer Technical solutions architects Wireless Desgin Engineer and if the candidate manages to pass Cisco Engineering Cisco Meraki Solutions exam, he/she will earn Cisco Meraki Solutions Specialist Certification. Below are some essential facts for Cisco 500-220 exam candidates:

TrendyCerts offers 72 Questions that are based on actual Cisco 500-220 syllabus.
Our Cisco 500-220 Exam Practice Questions were last updated on: Feb 28, 2025

Sample Questions for Cisco 500-220 Exam Preparation

Question 1

Where should a network admin navigate to investigate wireless mesh information between Meraki APs?

AWireless > Monitor > Access Points > AP > RF

BWireless > Configure > Radio Settings

CWireless > Monitor > Wireless Health

DWireless > Monitor > RF Spectrum

Correct : A

See Monitoring Mesh section Mesh monitoring tools are located at the bottom of every AP detail page, which can be accessed by navigating to Wireless > Monitor > Access Points, then clicking on an Access Point. https://documentation.meraki.com/MR/Wi-Fi_Basics_and_Best_Practices/Wireless_Mesh_Networking

Options Selected by Other Users:

Question 2

Refer to the exhibit.

500-220 Exam Question 2 Exhibit 1

During a Meraki AP deployment, the default SSID that the exhibit shows is broadcast. What causes this behavior?

AAn AP does not have a wired connection to the network.

BAn AP cannot connect to the default gateway.

CAn AP has never connected to the Meraki Cloud Controller.

DAn AP has Site Survey mode enabled.

Correct : C

If a Meraki Access Point does not have a configuration from the Meraki Cloud Controller it will instead broadcast a default SSID of 'Meraki-Scanning.'

<SSID_name>-scanning

Cause: Similar to 'bad-gateway', an AP is unable to connect to its default gateway.

https://documentation.meraki.com/MR/Other_Topics/Troubleshooting_local_connection_issues_using_default_SSID_on_MR_Access_Points

This is because the AP is broadcasting the default SSID ''meraki-scanning'' which is only broadcast when the AP has never connected to the Meraki Cloud Controller1.

This question is related to the topic ofWireless Access Points Quick Startin the Cisco Meraki documentation. You can find more information about this topic in theWireless Access Points Quick Startarticle or theUsing the Cisco Meraki Device Local Status Pagepage.