HPE6-A85 Exam Questions - Navigate Your Path to Success

The HP Aruba Certified Campus Access Associate Exam (HPE6-A85) exam is a good choice for HPE Aruba network field technician HPE deployment technician and if the candidate manages to pass HP Aruba Certified Campus Access Associate Exam, he/she will earn HP Aruba Certification. Below are some essential facts for HP HPE6-A85 exam candidates:

In actual HP Aruba Certified Campus Access Associate Exam (HPE6-A85) exam, a candidate can expect 60 Questions and the officially allowed time is expected to be around 90 Minutes.
TrendyCerts offers 102 Questions that are based on actual HPE6-A85 syllabus.
Our HPE6-A85 Exam Practice Questions were last updated on: Mar 09, 2025

Sample Questions for HPE6-A85 Exam Preparation

Question 1

A network technician at a branch office is connecting VolP phones to a newly configured AOS-CX switch. Users are complaining that voice quality is not as good as at the corporate office. Further investigation

shows the local-priority value at the branch office is 1 while at the corporate office is 5.

What describes the issue regarding the default QoS behavior on the AOS-CX switch?

AThe QoS trust is set to DSCP by default, and the VolP phone's local-priority value is mapped to 1.

BThe QoS trust is set to CoS by default, and the VolP phone's local-priority value is mapped to 1.

CThe QoS trust is set to none by default, and each VolP phone's local priority is configured for CoS map entry 1.

DThe QoS trust is set to none by default, and each VolP phone's local priority is configured for CoS map entry 0.

Correct : C

In an AOS-CX switch, if the QoS trust mode is not configured, it is set to none by default. The VoIP phones will mark their traffic with a local-priority value, which, if the QoS trust mode is none, will correspond to CoS map entry 1 by default. The local-priority value of 1 at the branch office likely indicates that the traffic is not being prioritized correctly compared to the corporate office, where a local-priority of 5 suggests a higher level of prioritization for voice traffic.

Options Selected by Other Users:

Question 2

What is a common use of LLDP for wireless access points?

Atesting the quality of the physical link between the access point and the switch

Bdiscovery of rogue access points

Cexchange of RF channel information with nearby access points

Dnegotiation of PoE power level to be provided to the access point

Correct : D

LLDP (Link Layer Discovery Protocol) is commonly used by network devices, including wireless access points, to negotiate PoE (Power over Ethernet) power levels with the switch they are connected to. This allows the access point to communicate its power requirements to ensure it receives the necessary power for optimal operation.